Related Manuals for Landa ECOS 7000
Summary of Contents for Landa ECOS 7000
- Page 1 OPERATOR’S MANUAL ■ ECOS 7000 1.103-825.0 98013160-1 US Patent: US-2011-0232696-A1 ® For technical assistance or the dealer nearest you consult our web page at www.landa.com 9.801-316.0...
-
Page 2: Table Of Contents
The model and serial numbers will be found on a decal attached to the pressure washer frame. You should record both serial number and date of purchase and keep in a safe place for future reference. 9.801-316.0 • Landa ECOS 7000 Operator Manual • Rev. 12/12... -
Page 3: Introduction
Pressure other If NHTSA receives similar complaints, it may open an than recommended pressure will lead to excessive tire investigation, and if it finds that a safety defect exists 9.801-316.0 • Landa ECOS 7000 Operator Manual • Rev. 12/12... -
Page 4: Wheel Lugs
Never attempt to tow skidding adjust brakes. your trailer with improper size ball. Always keep ball greased to avoid excessive wear. Replace worn hitch ball or locking dogs promptly. 9.801-316.0 • Landa ECOS 7000 Operator Manual • Rev. 12/12... -
Page 5: Brakes
This battery must be kept in a charged condition during operation and storage. The battery could prevent the normal operation of the brake if the trailer becomes uncoupled and/or freeze and break if it becomes discharged. 9.801-316.0 • Landa ECOS 7000 Operator Manual • Rev. 12/12... -
Page 6: Towing Instruction
5. Check brake magnets with an ohmmeter. The magnets should check 3.2 ohms. If shorted or worn The following two rules may limit your vehicle's towing excessively, replace. capacity and the tank fill level when towed. Determine 9.801-316.0 • Landa ECOS 7000 Operator Manual • Rev. 12/12... - Page 7 * Check lug nuts for tightness before initial trip, then at 10 miles, 25 miles and 50 miles. Recheck at least every 3 months or 3000 miles. 9.801-316.0 • Landa ECOS 7000 Operator Manual • Rev. 12/12...
-
Page 8: Warnings
RISK OF EXPLOSION: areas of the pressure washer. DO NOT SPRAY FLAMMABLE LIQUIDS. READ OPERATOR’S HOT SURFACES MANUAL THOROUGH- CAN CAUSE BURNS. LY PRIOR TO USE. 9.801-316.0 • Landa ECOS 7000 Operator Manual • Rev. 12/12 CAUTION WARNING WARNING... -
Page 9: Warnings
Follow the maintenance instructions 17. Inlet water must be clean fresh water and no hotter specified in the manual. then 90°F. 9.801-316.0 • Landa ECOS 7000 Operator Manual • Rev. 12/12... -
Page 10: Pre-Operation Check
• Cold clean fresh water supply (6 GPM • 3/4" (15.875 mm) • 20 PSI). • Hose, nozzle • Fuel (unleaded 86 or higher octane) • Check engine oil (oil level full) 9.801-316.0 • Landa ECOS 7000 Operator Manual • Rev. 12/12... -
Page 11: Setup Procedures
To clean the inlet screen, unscrew cap beneath the filter, remove the screen and rinse thoroughly with water. Then replace screen. 9.801-316.0 • Landa ECOS 7000 Operator Manual • Rev. 12/12... -
Page 12: Component Identification
Vacuum Hose Storage Box Vacuum Intake Filters Inner Water Vacuum Tanks Motor Outer Water Tanks 2-5/16" Coupler 98013160-17 Diesel - Gasoline Tank Compartment Safety Chains Break Away 7-Pin Cable Connector 9.801-316.0 • Landa ECOS 7000 Operator Manual • Rev. 12/12... -
Page 13: Assembly Instructions
Use a 12v Group 24 battery. Local purchase of battery will be the when trailer in not in use to pre- responsibility of the owner. Automo- vent the battery from draining. 9.801-316.0 • Landa ECOS 7000 Operator Manual • Rev. 12/12... -
Page 14: Pressure Washer Instructions
NOTE: Do not star t machine on the spray gun trigger. with burner switch on. The green light will be illuminated when the burner switch is in the on position. 9.801-316.0 • Landa ECOS 7000 Operator Manual • Rev. 12/12... -
Page 15: Detergent Instructions
DO NOT confuse this with a leak. box. The surface area amount is adversely minimized 9.801-316.0 • Landa ECOS 7000 Operator Manual • Rev. 12/12... -
Page 16: Vacuum Operation Instructions
Remove the filter and dispose of the contents per local regulations. Replace and secure the bag filter, lid and vacuum hose. 9.801-316.0 • Landa ECOS 7000 Operator Manual • Rev. 12/12... -
Page 17: Filter Replacement
Do not use soap or housing, make sure o- lose the black o-ring. other additives which may ring is in place, put it cause damage on the back in position and turn filter clockwise. 9.801-316.0 • Landa ECOS 7000 Operator Manual • Rev. 12/12... -
Page 18: Valve Operation
"ON" posi- tion. The bypass valve can FROM INNER TANKS be in the inner or outer tank position. 98013160-25 FROM OUTER TANKS 9.801-316.0 • Landa ECOS 7000 Operator Manual • Rev. 12/12... -
Page 19: Tongue Assembly Instructions
WARNING: Before towing trailer make sure that the fold-away hinge is locked into position with the hinge pin and cotter pin. VACUUM TANK DRAIN INSTRUCTIONS To drain vacuum tank disconnect the 3/4" JIC on bottom of tank. Re-connect hose when tank is empty. 3/4" JIC 98013160-5 9.801-316.0 • Landa ECOS 7000 Operator Manual • Rev. 12/12... -
Page 20: Troubleshooting
DO NOT ALLOW WASHER TO RUN water supply WITHOUT PROPER WATER SUPPLY. Hot water in pump Do not run in bypass for more than 5 minutes. Do not let water supply exceed 140°F (60°C). 9.801-316.0 • Landa ECOS 7000 Operator Manual • Rev. 12/12... - Page 21 Improper amount of oil in crankcase Adjust oil level to proper amount. OIL LEAKS Worn pistons and/or leaking crank seals, Replace seals, sleeves or O-Rings. crankcase cover seal or drain plugs 9.801-316.0 • Landa ECOS 7000 Operator Manual • Rev. 12/12...
-
Page 22: Troubleshooting
Replace part as necessary. PRESSURE Piston or valve worn Replace part as necessary. EXTREME PRESSURE Adjusting nut turned completely into Back off adjusting nut. SPIKES unloader Clogged nozzle Clean or replace. 9.801-316.0 • Landa ECOS 7000 Operator Manual • Rev. 12/12... -
Page 23: Maintenance & Service
15 seconds. under freezing conditions. Turn the key to the OFF position. • Remove the inlet feed line from the antifreeze mixture and replace the plug. 9.801-316.0 • Landa ECOS 7000 Operator Manual • Rev. 12/12... - Page 24 2-4 hours or until the color changes. 5. After circulating solution flush entire system with fresh water. Reinstall wand assembly to spray gun, a 3/4" hose and front panels. 9.801-316.0 • Landa ECOS 7000 Operator Manual • Rev. 12/12...
- Page 25 The solenoid then closes, shutting off the supply of fuel to the combustion chamber. Controlling the flow of fuel 9.801-316.0 • Landa ECOS 7000 Operator Manual • Rev. 12/12...
-
Page 26: Maintenance & Service
If the desired position cannot be obtained using only the air shutter, lock the air shutter in as close a position as can be obtained, then repeat the above procedure on the air band setting. 9.801-316.0 • Landa ECOS 7000 Operator Manual • Rev. 12/12... -
Page 27: Maintenance Schedule
3 months or 500 hours thereafter. Use SAE 30 weight oil, non-detergent. Date Oil Changed No. Of Operating Hours Brand Name and Month/Day/Year Since Last Oil Change Type of Oil (See above) 9.801-316.0 • Landa ECOS 7000 Operator Manual • Rev. 12/12... - Page 28 Maintenance for axles, hubs and brakes is extremely important for protecting the longevity of your trailer. It is extremely important for your personal safety and the protection of others. Please, never shortcut axle, hub and brake service and maintenance. 9.801-316.0 • Landa ECOS 7000 Operator Manual • Rev. 12/12...
-
Page 29: Warranty
(Effective April 2011) We warrant to the original purchaser that each new part and accessory sold by Landa will be free from manufacturing defects in materials or workmanship in normal service for a period of one (1) year from date of purchase, provided it is installed properly and the equipment maintained in accordance with Landa’s instructions and manuals. - Page 30 Form #9.801-316.0 • Landa ECOS 7000 Operator Manual • Rev 12/12 • Printed in U.S.A. or Mexico...