Setup Procedures - Landa ECOS 7000 Operator's Manual

SAFETY INFORMATION & ASSEMBLY AND OPERATION

SETUP PROCEDURES

These machines are meant to be used at or near
the working area and under operator supervision. If
machine must be located out of sight of the operator,
special controls may be required for proper machine
operation and operator safety.
Always locate the trailer in the driest and safest place
possible. Avoid high traffic areas and use flashers and
safety cones. Position the trailer so that the hose can
be pulled directly off of the reel for use.
Avoid areas where water can be sprayed at machine.
Locate the equipment on a solid level area with slopes
for drainage. When operating upon unlevel ground, posi-
tion trailer with hitch end at the downhill side.
WARNING: Do not unhitch or operate trailer
unhitched on unlevel ground.
Before using the trailer, make sure there are no
impurities in the incoming water supply. Turn the
water source on for at least 15 seconds, to remove any
possible debris in the water before connecting hose to
water supply.
The inlet screen located inside the filter should be
cleaned before each use. Filter is located behind valve
panel and can be accessed from underneath or by
removing small access panel in control cabinet. To
clean the inlet screen, unscrew cap beneath the filter,
remove the screen and rinse thoroughly with water.
Then replace screen.
11
9.801-316.0 • Landa ECOS 7000 Operator Manual • Rev. 12/12