Remarks; Related Sp Mode - Ricoh G092 Service Manual

6.7.5 REMARKS

• The machine does not print reports specifically for USB.
• Only one host computer is allowed for the USB connection.
• After starting a job using USB, do not switch the printer off until the job has been
completed.
When a user cancels a print job and data transmitted to the printer has not been
printed at the time of cancellation, the job will continue to print up to the page
where the print job was cancelled
• When the controller board is replaced, the host computer will recognize the
machine as a different device.

Related SP Mode

"USB Settings" are located in the printer engine service mode. Data rates can be
adjusted to full speed fixed (12 Mbps). This switch may be used for troubleshooting
if there is a data transfer error using the high-speed mode (480 Mbps).
Data rates can also be adjusted using the UP (User Program) mode "USB Setting"
in the Host Interface in the System menu.
This mode can be accessed only when the "Enter", "Escape", then "Menu" keys are
pressed (individually, not together) to enter the UP mode.
SM 6-59
USB
G081/G092