Siemens 6SE2101–1AA01 Operating Manual page 25

Parameter Parameter
Description
Number Number
P06
VOLTAGE
(continued)
100
VOLTAGE
100
VOLTAGE
100
VOLTAGE
100
Curve type
P16
P07 Minimum frequency
P08 Maximum frequency
P09 Digital frequency set–point
adjustment
P10∗
Analogue frequency set–point
adjustment
Display
Setting
(Factory
Setting)
120 400
FREQUENCY
50 400
FREQUENCY
400
60
FREQUENCY
400
Knee Point
P15
FREQUENCY
00.0 –
399 Hz
00.1 –
400 Hz
00.0 –
400 Hz
(50.0)
080 –
240%
(100)
5/8
Notes
003 Linear 0–120 Hz
100% 120–400 Hz
004 Voltage (frequency)
100% 50–400 Hz
Suitable for use with pumps and fans.
005 Voltage (frequency)
100% 60–400 Hz
Suitable for use with pumps and fans.
006 User–defined curve.
When this value is selected, the 'knee point'
and curve type must be selected using
parameters P15 and P16.
(000)
[001]
Sets the minimum selectable operating
frequency. This is temporarily overridden
while starting or stopping the motor.
The Jog frequency may also be set below P07.
Notes: (1) With Tacho Mode (P30) = 001 or
003, the inverter will stop under
closed loop control until P37 <
P07 + 0.5 Hz.
(2) When the inverter ramps down
due to current overload, it will
trip with F00 when the output
frequency reaches P07.
(00.1)
Sets the required maximum frequency limit.
Note that the setting of this parameter will
affect the scaling of the analogue control
input (P04) and ramp rates P02 and P03.
(50.0)
[60.0]
This parameter sets the frequency to which
the inverter will run at startup when parameter
P04 has been set to 003 or higher. This value
may be updated automatically during
operation in certain operating modes selected
via P04.
[60.0]
This parameter allows the output frequency at
a given control voltage/current input to be
trimmed. Adjusting this parameter from 100(%)
to 080(%) will reduce the frequency
corresponding to an analogue input voltage of
10 V (or 20 mA) by a factor of 0.8. Setting the
parameter to 240(%) will increase the
frequency by a factor of 2.4.
English
1.5
0–50 Hz
1.5
0–60 Hz