Siemens 6SE2101–1AA01 Operating Manual page 29

Parameter
Description
Number
P27 Third Fixed Frequency
P28 Fourth Fixed Frequency
P29 Skip Frequency
P30 Tachometer Mode
P31∗ Tachometer Scale Factor
P32∗ Feedback Compensation:
Proportional Term (%)
P33∗ Feedback Compensation:
Integral Term (%)
P34∗ Feedback Compensation:
Differential Term (%)
P35∗ Tachometer Slip Limit (Hz)
P36∗ Tachometer Sample Rate
5/12
Display
Setting
Notes
(Factory
Setting)
00.0 – Fixed frequency.
400
(00.0)
00.0 – Fixed frequency.
400
(00.0)
00.0 – This parameter allows a skip frequency to be
400 selected. Operation of the inverter will be inhibited
over the range (skip frequency – 2 Hz) to (skip
frequency + 2 Hz). If a frequency in this range is
selected, the lower or higher frequency will be
selected and displayed. Note that during ramping
the frequency output will ramp continuously and
not 'step' through the skip range.
(00.0)
This parameter enables the tachometer input
and selects the tachometer calculation rate. See
section 6 for further details of tachometer
applications.
000 Tachometer input disabled.
001 Normal feedback.
002 Feedback control suspended during ramping.
003 As 001, except output disabled when frequency
falls to P07 (minimum frequency).
004 As 002, except output disabled when frequency
falls to P07 (minimum frequency).
(000)
00.1 – Frequency at 50 V tacho input.
999
See section 6 for further details.
(50.0)
000 – See section 6 for further details.
999
(050)
000 – See section 6 for further details.
250
(000)
000 – See section 6 for further details.
250
(000)
00.0 – See section 6 for further details.
20.0
(05.0)
001 – n x 30 ms
200
See section 6 for further details.
(001)
English