WAGNER TITANUS Technical Manual page 116

Installation
5.12 Inserting the detection unit in the
ATTENTION
5 – 30
device base unit
Fig. 5.30: Installing the TITANUS MICRO·SENS
The components on the board are to be protected against damage from
electrostatic charges.
Proceed as follows to insert the TITANUS MICRO·SENS
base unit:
1
Put the device in the pre-mounted device base. When inserting
the detection unit, note the mechanical coding, this protects the
device against twisting.
2
Screw the four screws on the detection unit down tight using a
screwdriver.
Data: 01/09
TITANUS MICRO·SENS
2
®
aspirating smoke detection system
®
in the device
®
MS_A_05-en-e