Table of Contents
Advertisement
Depart. Technical support- CM640
PHILIPS Consumer
Communications
Centre du Mans
9.3.13
Insert "Microphone Label"
Push shock pad up, alignment with Front housing Base protruding. (As photo 4)
Take "Microphone Label", position by down side, paste it on Front housing Base relative position,
press around well, ref. photo 5
9.3.14
Insert "Screws cover"
Be careful, there is "Screw cover Base" and "Screw cover Flip". Do not invert them.
Identification Mark must be directed to the top (toward LCD Module)
PHILIPS ELECTRONICS N.V. 1999
All rights reserved. Reproduction in whole
or in part is prohibited without the written
consent of the copyright owner.
PROCEDURE
Service Repair Support
Identification marks
COMPANY RESTRICTED
VY-V-640-P655
Page : 66 of 74
Langue : EN
Date : 03/01/05
Microphone Label
VY-V-640-P655
Advertisement
Table of Contents
