Panasonic Lumix DMC-LS80 Operating Instructions Manual page 91

• Do not use any other USB connection
cables except the supplied one.
• While [ACCESS] is being displayed,
do not disconnect the USB connection
cable.
When connecting the camera to a
•
Windows 2000 OS PC with the USB
connection cable, do not replace the
card while the camera and the PC
are connected. The information on
the card may be damaged. Before
changing cards, make sure you do
the necessary steps to safely remove
hardware (double-click the icon in the
task bar in Windows).
• When using Windows PC, click Safety
Remove Hardware icon on the task trey
fi rst to remove USB cable.When the
icon is not displayed, make sure the
connection screen is not displayed, and
turn the camera [OFF] to remove.
• When there are many pictures on the
built-in memory or the card, it may take
some time to transfer them.
• Motion image fi les in the built-in memory
or on a card in this unit may not play
properly on a computer, so upload them
to your computer for playback.
• If the remaining battery power becomes
low while the camera and the PC are
communicating, the status indicator
blinks and the alarm beeps. In this case,
stop the communication at once on the
PC.
• Pictures edited or rotated with a PC may
be displayed in black in playback mode,
multi playback and calendar.
• Refer to the operating instructions of the
PC, too.
• If a card is not inserted when the camera
is connected to the PC, you can edit or
access the picture data on the built-in
memory. If a card is inserted, you can
edit or access the picture data on it.
VQT1L68_DMC-LS80_GN_EN.indd 91 VQT1L68_DMC-LS80_GN_EN.indd 91
Connecting to other equipment
• You cannot switch between the built-in
memory and the card while the camera is
connected to the PC. When you want to
switch between the built-in memory and
the card, disconnect the USB connection
cable, insert (or remove) the card and
then connect the USB connection cable
to the PC again.
91
VQT1L68
2007/12/13 11:09:11 2007/12/13 11:09:11