13-3.During Washing - Haier DW12-PFE2-E Service Manual

Service Manual
Issue
Rev.
Model No: DW12-PFE2-E/DW12-PFE2-U/DW12-PFE2ME-U
When the time-remaining indicators " E5" blinks.
Have you checked whether:
The water is turned on and the hose is connected properly.
The water supply to the house is on and has sufficient pressure.
The water supply hose is creased or kinked.
The filter for the water supply hose is clogged.
The drain hose is too low.
If you take all these checks and the dishwasher still does not function or your dishwasher
have any other error display, you can power the dishwasher OFF, and wait a few
minutes. You can power the dishwasher on, try it again , if the dishwasher still does not
function and/or the problem persists, contact the nearest authorised service center and
provide them with the following information:
the nature of the problem.
the model type number (Mod...) And the serial number (S/N...), which are indicated on the plate
located on the side of the inner part of the door.
Lower spray arm rotates with difficulty
Spray arm is blocked by small items or food remains.
Lid in detergent compartment cannot be closed
Detergent compartment has been overfilled.
Mechanism is clogged with remnants of detergent.
Indicator lamps do not extinguish after washing has finished
Main switch is still set to ON.
Remnants of detergent stuck inside dispenser
Compartment was damp when it was filled up with detergent. Compartment must be dry before
detergent is added.
Water remains inside appliance after programme has ended
Blockage or kind in drainage hose.
Pump is jammed.
Filters are blocked.
The programme is still running. Wait for the programme to end .

13-3.During washing

Unusual amount of foam is creased
Normal washing up liquid has been poured into the rinse-aid container.
Remove any spilled rinse aid with a cloth as it could otherwise lead to excessive foaming during
27