Table of Contents
Advertisement
ENGLISH
2. SETUP
2.1.
Installation
Pay attention to safety! Please respectively consider the EN 60598-2-17 and
the national standard during the installation. The authorized dealer must
only carry out the installation.
The installation of the fixture has to be built and constructed in a way that it can hold
10 times the weight for 1 hour without any harming demolition. The installation must
always be secured with a secondary safety attachment, e.g. an appropriate catch net.
This secondary safety attachment must be constructed in a way that no part of the
installation can fall down if the main attachment fails.
When rigging, de-rigging or servicing the fixture staying in the area below the instal-
lation place, on bridges, under high working places and other endangered areas is
forbidden. The operator has to make sure that the safety measure and the machine's
technical installation is approved by an expert before taking into operation for the first
time and after changes before taking into operation anther time. He has also to make
sure that an expert approves safety measure and the machine's technical installation
once a years.
WARNING: The fixture should be installed outside areas where persons may
walk by or be seated.
IMPORTANT: Overhead rigging requires extensive experience, including
(but not limited to) calculating working load limits, installation material
being used, and periodic safety inspection of all installation material and
the projector. If you lack these qualifications, do not attempt the installation
yourself, but instead use a professional structural rigger. Improper installa-
tion can result in bodily injury or property loss.
If the fixture shall be lowered from the ceiling or high joists, professional trussing
systems have to be used. The fixture must never be fixed swinging freely in the room.
Before rigging make sure that the installation area can hold a minimum point load of 10
times the projector's weight.
CAUTION: Fixture may cause severe injuries when crashing down. If you
have doubts concerning the safety of a possible installation, do not install
the fixture!
CAUTION: Use two appropriate clamps to rig the fixture on the truss. Follow
the instructions mentioned at the bottom of the base. Make sure that the
device is fixed properly! Ensure that the structure (truss) to which you are
attaching the fixtures is secure.
DANGER OF FIRE! When installing the device, make sure there is no highly
8
MTR-25-10W-RGBW User manual
Advertisement
Table of Contents
