Montarbo W22As Instruction Manual page 13

2 A 8
2 A 4
-
Important !
Wiring of the power cable for the PowerCon
connector (supplied with the unit).
Strip the cable for 20 mm of length and strip each wire for 8 mm of
length. We suggest to use a power cable with 1,5 ÷ 2 mm
wires (the insert terminals can however support a cable with wires up
to a section of 4 mm /12AWG).
2
Insert the power cable into the bushing and into the chuck (white
chuck for a cable diameter of 5 ÷ 11 mm; black chuck for a cable
diameter of 9.50 ÷ 15 mm). Insert the wires into the terminals and
fasten the clamping device by a flat screw driver.
The wire ends can be clamped in or soldered to the terminal, always
paying attention to the symbols shown on the connector:
L (Live - corresponding to the brown wire),
N (Neutral - corresponding to the light blue wire) and
(Ground - corresponding to the yellow and green wire).
After connecting the wires to the insert, lead the cable through the
housing and screw down the bushing.
14
ENGLISH
2 A 2
-
bi-amped, active loudspeaker systems
®
2 section
20 mm
8 mm
cable
wires
wires cable
chuck
insert
inside view
housing
bushing
setscrews
®
power con connector