Complete The Installation; Leveling (If Needed); Aligning The Doors (If Needed) - Haier HRQ16N3 Installation And User Manual

When Moving Your Refrigerator:
Your refrigerator is heavy. When moving the refrigerator
for cleaning or service, be sure to cover the floor with
cardboard or hardboard to avoid floor damage. Always pull
the refrigerator straight out when moving it. Do not wiggle or
"walk" the refrigerator when trying to move it, as floor damage
could occur.
CLEAN BEFORE USING
After you remove all of the packaging materials, clean the inside
of the refrigerator before using it. See the cleaning instructions in
"Refrigerator Care."
Important information to know about glass shelves and
covers:
Do not clean glass shelves or covers with warm water when
they are cold. Shelves and covers may break if exposed to
sudden temperature changes or impact, such as bumping.
Tempered glass is designed to shatter into many small, pebble-
size pieces. This is normal. Glass shelves and covers are heavy.
Use both hands when removing them to avoid dropping.

COMPLETE THE INSTALLATION

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove the ground prong from the power
cord plug.
Do not use an adapter.
Do not use an extension cord.
Failure to do so can result in death, re or
electrical shock.
1. Plug into a grounded 3 prong outlet.
2. Return all removable door parts to door and food to refrigerator.
NOTE: This refrigerator begins operating as soon as it is connected
to the power supply.
LEVELING
(IF NEEDED)
The refrigerator must be level to maintain optimal performance and
appearance.
1. Move the refrigerator to its final location.
2. Turn the feet on the bottom, front of the cabinet to raise or
lower that side of the refrigerator until the refrigerator is level
side-to-side.
3. Turn both front legs, by the same amount, to slightly raise the
front of the refrigerator. This will make it easier for the doors to
close.
NOTE: Having someone push against the top of the refrigerator
takes some weight off the leveling screws. This makes it easier
to turn the screws.
ALIGNING THE DOORS
(IF NEEDED)
If the edges of the refrigerator doors do not align with each other,
you can make adjustments:
Using Adjustable Foot
•
Turn the adjustable foot to raise or lower that side of the
refrigerator.
•
Clockwise - to raise
•
Counterclockwise - to lower
Using Spacers (provided)
•
Open the door. With the door open, lift the door upward.
•
By hand or using pliers, clip the spacer (provided) onto the
center hinge pin.
a
Spacer (provided)
a
5