Product Status Messages - Epson ET-3600 User Manual

Parent topic:

Product Status Messages

You can often diagnose problems with your product by checking the messages on its LCD screen.
LCD screen message
Printer error 0xXX
A printer's ink pad is
nearing the end of its
service life.
A printer's ink pad is at
the end of its service life.
Communication error
Paper jam
Invalid IP address and
subnet mask
Recovery mode
Note: The ink pads in the printer collect, distribute, and contain the ink that is not used on printed pages.
During the life of your product it may reach a condition where either satisfactory print quality cannot be
maintained or the ink pads have reached the end of their usable life. The Epson Status Monitor, your
LCD screen, or lights on the control panel will advise you when these parts need replacing. If this
happens during the standard warranty of the product, the exchange of the product or replacement of the
pads is covered under the standard warranty. If the product is out of warranty, the pads can be replaced
by any Epson authorized service provider. The waste ink pads are not a user-replaceable part.
Parent topic:
Related references
Where to Get Help
Solving Problems
Condition/solution
Turn off the product, make sure no paper is jammed, then turn it back on
again. If the error continues, contact Epson for support.
The ink pad is near the end of its service life, contact Epson for support. (To
continue printing, press one of the Start buttons.)
The ink pad is at the end of its service life. Turn off the product and contact
Epson for support.
Make sure the computer is connected to your product and your software is
installed correctly.
Paper is jammed in the product. Remove the jammed paper and press the
OK button to clear the error.
Enter the IP address and subnet mask correctly.
An error has occurred during firmware updating. Connect your product using
a USB cable and try updating the firmware again. If you still receive this error
message, contact Epson for support.
Solving Problems
145