Trouble-Shooting - Braun 9 SERIES Manual

Trouble-Shooting

Problem:
SHAVER
Shaver does not
start when
pressing the
start button.
Shaver does not
charge
completely and
keeps blinking.
Charging does
not start when
connected to
power socket or
put in charging
stand /
Clean&Charge
Station.
Unpleasant smell
from the shaver
head.
Battery
performance
dropped
significantly.
Shaving
performance
dropped
significantly.
32
Possible reason:
1. Travel lock is activated.
2. This appliance can
only be operated
cordless.
Ambient temperature is
out of valid range.
1. Shaver is not placed
properly in the
charging stand /
Clean&Charge Station.
2. Sometimes charging
could start delayed
(e.g. after long
storage).
3. Ambient temperature
is out of valid range.
4. Special cord set is not
plugged in properly.
1. Shaver head is
cleaned with water.
2. Cleaning cartridge is in
use for more than 8
weeks.
1. Shaver head is
regularly cleaned
with water but not
lubricated.
2. Foil and cutter are
worn which requires
more power for each
shave.
1. Shaving system is
clogged.
2. Foil and cutter are
worn.
Remedy:
1. Press the on/off switch for 3 seconds
to unlock the shaver.
2. Unplug the shaver.
Recommended ambient temperature
for charging is 5 °C to 35 °C.
1. Contacts of shaver need to align with
contacts in the Clean&Charge
Station.
2. Wait a few minutes, if charging will
start automatically.
3. Recommended ambient temperature
for charging is 5 °C to 35 °C.
4. Special cord set needs to snap into
place.
1. When cleaning the shaver head with
water only use hot water and from
time to time some liquid soap
(without abrasive substances).
Remove Foil & Cutter cassette to let
it dry.
2. Change cleaning cartridge at least
every 8 weeks.
1. If the shaver is regularly cleaned with
water, apply a drop of light machine
oil on top of the foil once a week for
lubrication.
2. Replace Foil & Cutter cassette.
1. Soak the Foil & Cutter cassette in hot
water with a drop of dish liquid.
Afterwards rinse it properly and tap it
out. Once dry apply a drop of light
machine oil on the foil.
2. Replace Foil & Cutter cassette.