Quick Setup; Connection Diagram; Installation - ION KEYSTONE Quick Start Manual

Quick Setup

Connection Diagram

Items not listed under
Smartphone,
tablet, etc.
Remote

Installation

Keystone may be used freestanding or mounted. When used freestanding, the rubber feet on the
bottom of the speaker allow Keystone to sit comfortably on any flat surface. To mount Keystone
using the included wall mount, follow the instructions below. If using the solar panel to prolong
battery life between charges, place Keystone in an area that receives at least 3 hours of direct
sunlight a day for best results.
To use Keystone with the included wall mount, first inspect the area where you would like to install
the speakers. Confirm that the surface you are mounting Keystone on can safely hold the weight of
the speaker (8.4 lbs. / 3.8 kg). If you are unsure whether you can safely install Keystone in your
desired location, please consult a professional contractor.
To install the wall mount:
1. Insert screws into the 4 holes on the wall mount base. Fully tighten all screws so the wall mount
base is flush with the surface before placing the speaker on the mount. Do not use the included
screws to mount Keystone on surfaces such as concrete or drywall, as these may require special
tools and/or hardware.
2. Loosen the mount knob to adjust the angle of the mounting post. Once the desired angle is
achieved, tighten the mount knob, ensuring that the adjustment teeth are fully interlocked.
3. Loosen the speaker attachment knob on the back of Keystone enough to allow the unit to slide
onto the mounting post.
4. Slide Keystone onto the mount so that the mounting post is fully inserted into the mounting hole
on the bottom of the speaker. Make sure it is unobstructed on all sides for optimal performance.
5.
Tighten the speaker attachment knob to secure Keystone to the wall mount at the desired
rotational orientation.
4
Introduction > Box Contents
Power
are sold separately.
Side Panel
Bottom Panel
Wall Mount