Gigaset C450 IP Manual page 10

Hide thumbs Also See for C450 IP:
Table of Contents

Advertisement

The polarity is indicated in the battery
compartment.
The handset switches on automatically.
You will hear a confirmation tone.
Closing the battery cover
¤
Place the cover on the battery compart-
ment as shown in the diagram, then
push it up until it clicks into position.
Opening the battery cover
¤
Press down on the battery cover below
its upper end and slide the cover down.
Connecting the charging cradle
Connecting up the charging cradle and
mounting it on the wall (if required) is
described at the end of this user guide.
¤
To charge the batteries, leave the hand-
set in the charging cradle.
Please note:
– Only place the handset in the charging cra-
dle that is intended for it.
– If the handset has switched itself off
because the batteries are flat and if it is
then placed in the charging cradle, it will
switch itself on automatically.
For questions and problems see page 67.
Initial charging and discharging of
batteries
Battery charging is indicated in the top
right of the display by a flashing battery
icon e, V or U. During handset
operation, the battery icon indicates the
charge status of the batteries (page 1).
The correct charge status can only be dis-
played when the batteries are first fully
charged and discharged through use.
¤
To do this, leave the handset in the
charging cradle without interruption
until the battery icon stops flashing in
the display (approx. 13 hours).
¤
Once the batteries are fully charged,
remove the handset from the charging
cradle and do not put it back again until
the batteries are fully discharged.
Please note:
After the first battery charge and discharge,
you may replace your handset in the charging
cradle after every call.
Please note:
u
Always repeat the charging and dis-
charging procedure if you remove the
batteries from the handset and insert
them in again.
u
The batteries may warm up as they are
charging. This is not dangerous.
u
After a while the charge capacity of the
batteries will decrease for technical rea-
sons.
Please note:
You will find explanations for the symbols and
typographical conventions used in this user
guide in the appendix, page 66.
First steps
7

Advertisement

Table of Contents
loading

Table of Contents