Charging The Battery; Power Camera On And Off; Initial Settings - Sealife DC2000 Instruction Manual

Charging the Battery

To charge the battery, connect camera to USB cable and other end of USB cable to the wall charger,
as shown.
• The LED indicator on the back of the camera will begin flashing slowly when camera is charging
and turns off when charging is complete.
• If the LED indicator does not flash when attempting to charge the battery, make sure the battery is
properly installed and that the contacts are cleaned.
• If the LED indicator lights flashes rapidly, the battery may be damaged or useful life may have
expired. Replace the battery in this case.

Power Camera On and Off

There are two ways to power on the camera:
• Push and hold the Power button until camera powers on. The camera will power on in Photo
mode.
• Push and hold the Playback button, the camera will power on in Playback mode.
• To power OFF the camera, push the Power button.

Initial Settings

When powering on the camera for the first time, you will be asked to set your local language and the
date/time:
Setting the Language
1. Use the 4-way navigation button ( , , or ) to select your preferred language.
2. Push OK to confirm your language selection.
18