Wiring A Transmitter; Overview; Figure 14 - Transmitter Operating Ranges; Figure 15 - Transmitter 3-Screw Terminal Board And Grounding Screw - Honeywell ST 800 User Manual

3.6 Wiring a Transmitter

3.6.1 Overview

The transmitter is designed to operate in a two-wire power/current loop with loop resistance and
power supply voltage within the operating range shown in Figure 14.
Figure 14 – Transmitter Operating Ranges
Loop wiring is connected to the Transmitter by simply attaching the positive (+) and negative (–) loop
wires to the positive (+) and negative (–) terminals on the Transmitter terminal block in the
Electronics Housing shown in Figure 15.
Figure 15 – Transmitter 3-Screw Terminal Board and Grounding Screw
ST 800 SmartLine Pressure Transmitters User's Manual
Page 20 Revision 10