GE PNRQ15RBL Owner's Manual & Installation Instructions page 14

Feed Water Supply (Cont.)
B. OPTIONAL INSTALLATION 1
(CONT.)
4. Assemble adapter (C) and coupling (D) as shown
Ensure that the gasket (G) is in place before final
assembly. Start installation by hand, then finish
tightening with adjustable wrench. Be careful not
to overtighten or cross-thread since damage to
threads may occur.
5. Hand-tighten assembled adapter (C) onto supply
valve (A) for the proper size installation. Be sure
gasket (G) is in place before final assembly. Start
installation by hand; then finish tightening with an
adjustable wrench.
Be careful not to overtighten or cross-thread
since damage to threads may occur.
(C).
7. Cut wire ties on tubing coils, using care not to
damage tubes or parts if using a utility knife.
8. Remove the 1/2" nut (I) and ferrule (H) from end
of inlet valve. Using the yellow banded tubing
provided, place the nut (I) and ferrule (H) onto
the tubing and install onto inlet valve (F) as
shown at left. Tighten with adjustable wrench. Be
careful not to overtighten or cross-thread since
damage to threads may occur.
NOTE: Inspect the ends of the tubing prior to
installation to be sure there are no imperfections and
that the end of the tubing is cut square. It may be
necessary to cut the tubing again.
14
Installation Instructions
C. OPTIONAL INSTALLATION 2
Where codes permit (Requires additional parts)
*For 1/2" OD or larger metal tubing only.
NOTE: Codes in certain states require installation
by a licensed plumber and do not permit the use of
the saddle valve. For installation, use plumbing code
248-CMR of the Commonwealth of Massachusetts.
Saddle valve is available through GE Appliances
WS15X10023. Self-piercing saddle valves are not
recommended.
1. Turn off the cold water supply and attach saddle
valve as required by product selection. (Be sure
to follow manufacturer's Installation Instructions.)
WARNING
Many homes are electrically
grounded through the plumbing. To protect
yourself from serious injury or fatal shock, use a
battery-powered hand drill only to make the hole.
DO NOT USE AN ELECTRIC DRILL.
2. Close the water supply valve by turning the
handle clockwise.
3. Open the main water supply valve and several
house faucets to purge air from the system.
Close faucets when water runs smoothly.
Some threads
should be visible
Rubber gasket
Optional water supply connection (using saddle valve)*
*For 1/2" OD or larger metal tubing only.
Pre-drill
Nut (2)—not 1/4" hole
required if holes
in clamp are
threaded
Clamp Z
Washer
Tubing adapter
Compression
nut
Use to connect the tubing
Snug valve into bracket
(DO NOT OVERTIGHTEN)
Seal—make sure the
seal is in place
Clamp X
Valve
Handle
49-6000065