Table of Contents
Advertisement
ABOUT MY DESIGN CENTER
ABOUT MY DESIGN CENTER
With My Design Center, you can use the functions listed below:
• Hand-drawn functions - creating embroidery patterns by drawing on the LCD screen
• Scanning functions - creating embroidery patterns by not only scanning object with built-in camera, but also
imported data from USB media, SD card or computer.
You can also combine patterns that you have created with the machine's built-in patterns.
Starting My Design Center for
the First Time
My Design Center will be activated once the
scanning frame has been attached. After the initial
activation is complete, you no longer have to
attach the scanning frame. View the tutorial video
that shows how to use My Design Center.
Memo
• This is required only for the first time that
My Design Center is used. After the first
time, My Design Center will be available
even if the scanning frame is not attached.
• In order to use My Design Center after
upgrading the machine, attach the scanning
frame to enable My Design Center.
■ Attaching the Scanning Frame
1. Remove the two thumb screws securing the
embroidery frame holder, and then remove the
frame holder from the machine.
a Thumb screws
3
2. Install the needle plate cover included with the
machine.
a Needle plate cover
Memo
• For best scanning results, be sure to install
the needle plate cover.
3. Align the holes in the scanning frame with the
pins on the frame-mounting plate of the carriage.
a Pins on the frame-mounting plate
b Holes in the scanning frame
4. Secure the scanning frame with the two thumb
screws removed in step
a Thumb screws
a
.
Advertisement
Table of Contents
