Marantz SA-10 Owner's Manual page 23

6
Press X.
When the unit power is turned on, the PC
0
automatically finds and connects to the unit.
7
Press DISC/INPUT to switch the playback
media mode to "USB-DAC".
8
Checking the installed driver.
A Click the "Start" button and click "Control Panel" on
the PC.
The control panel setting list is displayed.
0
B Click the "Sound" icon.
The sound menu window is displayed.
0
C Check that there is a checkmark next to "Default
Device" under in "SA-10S1" of the "Playback" tab.
When there is a checkmark for a different device,
0
click SA-10S1 and "Set Default".
9
Checking audio output.
Outputs a TEST signal from the PC and checks the
audio output from the USB-DAC function.
A Select "SA-10S1" and click "Properties".
The SA-10S1 Properties window is displayed.
0
SA-10S1
B Click the "Advanced" tab.
C Select the sampling rate and bit rate to be applied to
the D/A converter.
It is recommended that "2 channel, 24 bit, 192000
0
Hz (Studio Quality)" is selected (Windows 7).
It is recommended that "2 channel, 32 bit, 192000
0
Hz (Studio Quality)" is selected (Windows 8/
Windows 8.1/Windows 10).
D Click "Apply".
E Click "Test".
Check that audio from this unit is output from the
0
PC.
e
NOTE
The dedicated driver must be installed in the PC before this
0
unit is connected to a PC. Operation will not occur correctly
if connected to the PC before the dedicated driver has
been installed.
Player software supporting the Audio Stream Input Output
0
(ASIO) driver is required to play files with a sampling
frequency of 352.8 kHz/384 kHz without downsampling.
Check your player software before playing files with the
ASIO driver.
Operation may fail in some PC hardware and software
0
configurations.
Please see the FAQ at www.marantz.com if you
0
experience any issues getting audio to play from your
w
computer through the this unit. You may also want to check
the support pages for your audio player application.
t
r
ENGLISH
22