Panasonic FZ-Q2 Operating Instructions Manual page 21

NOTE
lÎ
• To change OS from 32 bit to 64 bit, or vice versa, install OS using the recoverypartition in
the flash memory.
• The recovery disc for Windows 10 cannot be created via the "Recovery Disc Creation Utility"
procedure in the Reference Manual.
To create a recovery disc for Windows 10, visit the following URL and then download data.
http://pc-dl.panasonic.co.jp/itn/support/recv/
Preparation
l Prepare the following items:
Î
• Recovery Disc (
disc.) (Î
Utility")
• USB DVD drive (optional) (refer to recent catalogs and other sources for information
about the products available)
l Remove all peripherals (except for the USB DVD drive).
Î
l Connect the AC adaptor and do not remove it until installation is complete.
Î
1 Connect the DVD drive to the USB port.
2 Start the Setup Utility.
A Touch (Start) - [Settings] - [Update & security] - [Recovery].
B Touch [Restart now] under "Advanced startup".
C Touch [Troubleshoot] - [Advanced options] - [UEFI Firmware Settings] - [Restart].
Turn on the computer, and touch top left of the screen while [Panasonic] boot screen is
displayed.
l If the [Panasonic] boot screen is not displayed, turn on the computer while touching top
Î
left of the screen.
l If the password is requested, enter the Supervisor Password.
Î
3 Write down all of the contents of the Setup Utility and touch [Exit] and
double-touch [Load Default Values].
At the confirmation message, touch [Yes].
4 Check the [Boot] setting of the Setup Utility.
[UEFI Boot] should be set to as follows.
When the recovery disc for Windows 10 is used: [Enabled]
When the recovery disc for Windows 7 is used: [Disabled]
5 Set the Recovery Disc into the DVD drive.
6 Touch [Exit] and double-touch [Save Values and Reboot].
At the confirmation message, touch [Yes].
Computer will restart.
7 Touch top left of the screen while [Panasonic] boot screen is dis-
played.
The Setup Utility starts up.
l If the password is requested, enter the Supervisor Password.
Î
8 Touch [Exit] and double-touch your DVD drive in [Boot Override].
The computer will restart.
USB memory device can also be used as a recovery
Operating Instructions - Reference Manual "Recovery Disc Creation
21