Operating Controls; For Your Safety - Bosch AKE 30-19 S Operating Instructions Manual

F 016 L70 558.book Seite 4 Donnerstag, 15. Januar 2009 3:18 15

Operating Controls

A
1 Rear handle
2 On/Off switch
3 Safety lock
4 Oil filler cap
5 Activation lever for kickback brake (hand
guard)
6 Deactivation mark for kickback brake
7 Front handle
8 Nose sprocket
9 Chain guard
10 Chain
11 Chain bar
12 Gripping teeth
13 Tensioning ring (red)
14 Locking knob
15 Cover plate
16 Chain tensioning catch
17 Fastening bolt
18 Guide fins for chain bar
19 Oil outlet
20 Symbol for rotation and cutting direction
21 Drive sprocket
22 Chain catch bolt
23 Mains plug**
24 Serial Number
**Country specific
Not all of the accessories illustrated or described are
included as standard delivery.

For Your Safety

Warning! Switch off, remove plug from mains
before adjusting cleaning or if the cable is cut,
damaged or entangled.
Caution! Do not touch rotating chain.
Do not operate chain saw near other people,
children or animals. Do not operate chain saw
after drinking alcohol or under the influence of
intoxicating drugs or medication.
Electrical Safety
Your machine is double insulated for safety and re-
quires no earth connection. The operating voltage is
230 V AC, 50 Hz (for non-EU countries 220 V,
240 V as applicable). Only use approved extension
cables. Extension cords/leads should only be used
if they comply with H07 RN-F types or IEC
(60245 IEC 66).
9 • F 016 L70 558 • TMS • 08.01.09
If you want to use an extension cable when operat-
ing your product, only the following cable dimen-
sions should be used:
2
– 1.0 mm : max length 40 m
2
– 1.5 mm : max length 60 m
2
– 2.5 mm : max length 100 m
It is recommended for increased electrical safety to
use a Residual Current Device (RCD) with a tripping
current of not more than 30 mA. Always check your
RCD every time you use it.
For products not sold in GB: WARNING: For
safety, it is essential that the mains plug 23 attached
to the machine is fitted to the power supply cable 25
as shown.
The couplings of connection leads must be pro-
tected against splashes and the coupling sockets on
the leads must be made of rubber or coated with
rubber.
Fixing means for the connection leads must be
used.
The connection lead must be inspected for signs of
damage at regular intervals and may only be used if
in perfect condition.
If the supply cord is damaged, it must be replaced by
a Bosch Service Centre.
Products sold in GB only: Your chain saw is fitted
with an approved 13 A (BS 1363/A) electric plug and
is protected by a 13 A fuse (ASTA Approved to
BS 1362).
If the fitted plug is not suitable for your socket out-
lets, it should be cut off and an appropriate plug fit-
ted in its place by an authorized customer service
agent.
The severed plug must be disposed of to avoid a
possible shock hazard and should never be inserted
into a 13 A socket elsewhere.
Assembly/Tensioning Chain
Do not connect the chain saw to mains be-
fore it is completely assembled.
Always use gloves when handling the chain.
Chain and chain bar Assembly
A
1. Unpack all parts carefully.
2. Align the two assembly arrows
sioning ring 13 and cover plate 15.
15
13
3. Place the chain saw on any suitable flat surface.
English - 4
on the ten-