Maintenance; How To Replace The Filter Bag - Hoover CH34006 User Manual

Maintenance

Any other servicing should be done by an authorized service representative.
If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into
water, take it to a service center prior to continuing use.
THERMAL PROTECTOR STATEMENT
A thermal protector has been designed into your cleaner to protect it from overheating.
When the thermal protector activates the cleaner it will stop running.
If this happens proceed as follows:
1. Turn cleaner OFF and unplug it from the electrical outlet.
2. Check fullness of bag, change if needed.
3. Inspect the air path for any obstructions. Clear obstructions if present.
4. When cleaner is unplugged and motor cools for 30 minutes, the thermal protector will deactivate
and cleaning may continue.
If the thermal protector continues to activate after following the above steps, your cleaner
needs servicing.
WARNING
TO REDUCE THE RISK OF PERSONAL INJURY: UNGPLUG BEFORE CLEANING OR SERVICING.
NOTE: When using the vacuum to pick up very fine dust, such as sawdust or drywall dust, it will be
necessary to replace the bag and clean the filters at more frequent intervals to maintain maximum
suction. Fine dust will clog bag pores and reduce suction, prior to bag becoming full.
1
Check filter bag. Change, if full.
14
2
Check for clogs in nozzle, wand,
hose, and bag inlet. Clear any
obstructions.

How To Replace The Filter Bag

WARNING
TO REDUCE THE RISK OF PERSONAL INJURY: UNGPLUG BEFORE CLEANING OR SERVICING.
1 2
Open top cover by Release full bag by
unlocking the 3 pressing the orange
latches. tab and pulling bag
out.
4 5
Press down to latch Replace top cover and
bag holder. secure latches.
REPLACEMENT BAGS
Standard Filtration 10 Pack Part No. AH10173
Allergen Filtration 10 Pack Part No. AH10273
3
Insert new bag by
sliding cardboard
under tabs until bag is
securely in place.
15