Table of Contents
Advertisement
To prevent future moisture and dust from getting inside the Video Door Station, make sure the rubber
Step 3
gasket on the inside panel of the Video Door Station completely covers and seals the Video Door
Station's faceplate against the Back Box.
Configure the Cisco Video Door Station
Procedure
To configure the Video Door Station in Composer Pro:
Open Composer Pro.
Step 1
Double-click the Video Door Station driver to add it to a room in the project.
Step 2
Identify the device to the project.
Step 3
(Wi-Fi only) For your convenience, the Cisco Video Door Station driver includes a meter to check Wi-Fi
Note
signal strength. Use System Manager in Composer Pro to configure the Wi-Fi parameters. See the
Composer Pro User Guide
Reset/Factory Restore the Cisco Video Door Station
Procedure
To reset or factory restore the Video Door Station:
Remove the faceplate and pull the Video Door Station out from the Back Box just enough to expose the
Step 1
Reset button (see
While powered press the Reset button on the bottom of the Video Door Station to reset or restore the
Step 2
Cisco Video Door Station.
When you are finished, insert the Video Door Station back into the Back Box and screw the faceplate
Step 3
back on.
Installing the Wi-Fi Antennas
We recommend installing the Cisco Video Door Station using wired Ethernet. Use the Wi-Fi option only
Note
if a wired Ethernet connection is not available.
OL-27367-01
for details.
Figure
8).
Quick press—Press to reset the Video Door Station.
•
Long press—Press until the button on the faceplate begins to blink rapidly. At that time, the
•
factory restore starts. This action restores the Video Door Station to its factory default settings.
Cisco Smart+Connected Video Door Station Reference Guide
Installing the Cisco Video Door Station
27
Advertisement
Table of Contents
