Cisco SCH-VDS-I Reference Manual page 22

Installing the Cisco Video Door Station
Figure 11 Ethernet with DC Power: External Video Door Station (Left) and Internal Video Door Station (Right)
1
Ethernet cable
2 Contacts and relays
3 DC Connections (hot and load)
4
Ground wire
Option 4: Wi-Fi Connection with AC Power
Use this option to connect Wi-Fi networking and AC power.
•
•
Procedure
Connect a ground wire from the Cisco Video Door Station to one of the Back Box lugs (see
Step 1
Connect a second earth-ground or house-ground wire from the second Back Box lug to the residence.
Step 2
See the
Connect the neutral (N) (-) and hot (L) (+) wires to the AC power source for the Video Door Station
Step 3
according to the national and local electrical codes.
Tip
Your installation may require alternative wires and the use of a terminal block. Strip the power wires to
Step 4
1/4" on the end if necessary.
Cisco Smart+Connected Video Door Station Reference Guide
22
Ensure that you have Wi-Fi in the residence.
Wi-Fi requires an antenna (sold separately). See the
"Grounding Requirements" section on page 9
The hot or 'L' (+) wire's connector is closest to the bottom of the Video Door Station's plate.
"Accessories" section on page
for details about earth grounding.
4.
Figure 12).
OL-27367-01