Cisco SCH-VDS-I Reference Manual page 15

IMPORTANT! Improper use or installation can cause LOSS/DAMAGE OF PROPERTY.
Warning
WARNING! Before you install the Cisco Video Door Station Back Box, switch off the circuit breaker
Warning
or remove the fuse from the fuse box.
Procedure
Feed either the AC, DC, or PoE wires through a tab in the back of the Back Box. See the
Step 1
Cisco Video Door Station" section on page 18
After you've placed the Back Box inside the wall, tighten the screws or nails.
Step 2
Attach the ground wires to the Back Box and Cisco Video Door Station plate in the location indicated
Step 3
by the ground symbol
There are two (2) ground screws in the Back Box: one (1) for earth ground and one (1) for grounding the
Cisco Video Door Station faceplate to the Back Box.
If you use Wi-Fi, the Wi-Fi antenna must be installed in the Back Box and extend outside the box.
Step 4
Note
OL-27367-01
(also, see
Do not allow any contact of the antenna element to any metal surface on the Back Box;
otherwise, antenna performance will diminish.
to determine your installation option.
Figure 6 and Figure 7).
Cisco Smart+Connected Video Door Station Reference Guide
Installing the Back Box
"Installing the
15