Cisco SCH-VDS-I Reference Manual page 24

Installing the Cisco Video Door Station
Option 5: Wi-Fi Connection with DC Power
Use this option to connect Wi-Fi networking and DC power.
•
•
Procedure
Connect a ground wire from the Cisco Video Door Station to one of the Back Box lugs (see
Step 1
Connect a second earth-ground or house-ground wire from the second Back Box lug to the residence.
Step 2
See the
Connect the negative (-) and positive (+) wires to the DC power source for the Video Door Station
Step 3
according to the national and local electrical codes.
Note
Your installation may require alternative wires and the use of a terminal block. Strip the power wires to
Step 4
1/4" on the end if necessary.
Attach the antenna (3m or 26cm) to the Cisco Video Door Station. See the
Step 5
Antennas" section on page 27
Run the antenna wire through the Back Box hole (see
Step 6
Back Box.
Align the antenna vertically to the wall outside the Back Box (26cm antenna) or run the antenna through
Step 7
the wall (3m antenna).
Cisco Smart+Connected Video Door Station Reference Guide
24
Ensure that you have Wi-Fi in the residence.
Wi-Fi requires an antenna (sold separately). See the
"Grounding Requirements" section on page 9
The positive (+) wire's connector is located on the bottom left side of the Video Door Station's
plate.
for details about earth grounding.
for details.
Figure
"Accessories" section on page
"Installing the Wi-Fi
17). Ensure that the wire doesn't touch the
4.
Figure 17).
OL-27367-01