Advertisement
20
How
to
dismantle
parts
Freezer
compartment
lamp
Dispenser lamp
Freezer
compartment
shelf
Door rack and
support
Ice
storage
bin
After
dispenser
is used
Seperate
the
lamp by pulling
it out, and then
remove
the
lamp.
Max. 15 W bulb for
refrigerator
is used and
can
be
purchased
at
a
service
center.
To
remove a
shelf,
lift the left
part
of the shelf
a
bit,
push
it
to
the direction
( ),
lift the
right
part
to
the diretion
( ),
and take it
out.
Lift the door rack
holding
both sides
( )
and
pull
it
out to
( )
direction.
The
water
collector has
no
self-drainage
function. So it should be cleaned
regularly.
Remove the
cover
by pressing
the left side of
water
collector
cover
and
dry
it with
a
cloth.
Press the
point
marked
as
shown in the
figure
to
the
right
to
remove
the
water
collector
cover.
Hold the ice
storage
bin
as
shown in the
right
figure
and
pull
it
out
( )
while
slightly lifting
it
( ).
It is recommended
not to
dismantle the ice
storage
bin unless it is necessary.
Be
sure
to
use
both hands when
removing
the ice
storage bin,
so as
not to
drop
it
on
the
floor.
If the ice
storage
bin does
not
fit
well,
slightly
rotate
the
rotating
device.
?
Dismantling
is done in the
reverse
sequence of
assembly.
Be
sure
to
unplug
the power
plug
before
dismantling
and
assembly.
Never
apply
severe
force
to
dismantle
parts.
Parts may be
damaged.
NOTE
Care and maintenance
Separate
the
lamp by pulling
it
out
( )
while
slightly striking
( )
and
rotating
( )
the
lamp
cover.
Turn the bulb counterclockwise. Max. 40 W bulb
for
refrigerator
is used and
can
be
purchased
at
a
service
center.
Advertisement
