Whirlpool MW8750XL Use & Care Manual page 9

The Display WIII show the numbers You
touched
in the order you touched them.
Thus example shows 2 minutes 30 seconds
3. Touch Number Pads for
the defrosting time you
want.
m
4.
Touch START.
. .
q 1 '.
d
count
own
STANDING TIME
The QUICK DEFROST Signal Light WI/I stay on
to show that the oven IS in the QUICK
DEFROST Cycle
The Display counts down the time to show
how much defrosting time
IS
left
When the defrost time ends, you WIII hear
4
beeps [You can stop the beeping by
openrng the oven door or touching
CANCEL] When the beeping stops the
Drsplay will show the time of day
For best results, allow the food to stand for a while after defrosting This helps equalize
the temperature of the food to provide more even defrostrng
When COOK CYCLE 1 follows QUICK DEFROST, the oven automatically provtdes a
standing time equal to the trme touched in for QUICK DEFROST COOK CYCLE 1
will
begin after the automatic standing time
For a different standing trme:
I. Touch QUICK DEFROST and desired time
2 Touch COOK CYCLE 2.
3. Touch numbers for desired standing time
4. Touch COOK POWER
5. Touch "0" for zero Cook Power.
6. Touch START.
When the QUICK DEFROST is over, the oven will shut off The Display will count down
the time for COOK CYCLE 2 at zero Cook Power. You will hear 4 beeps when the
standing time is over.
ABOUT THE "QUICK DEFROST" CYCLE
The microwave oven automatically divides the time set for the QUICK DEFROST
Cycle into three equal parts.
- First part 80% of full Cook Power,
-Second part 50% oi full Cook Power
-Third part 20% of full Cook Power.
This automatic step-down in Cook Paw& is an important part of the QUICK DEFROST
Cycle. It helps defrost food quickly and completely
CHANGING OR ADDING DEFROST TIME
You can change the time setting any time while the QUICK DEFROST Cycle is
operating:
1. Touch QUICK DEFROST.
2. Touch numbers for the new time.
3. Touch START.
Any new time setting made while QUlCK DEFROST is operating will continue the
defrosting only at 20% of full Cook Power.
The best time to change the setting is near the end of the QUICK DEFROST Cycle.
1. Open the door.
2 Check the food with long-tined fork; if center area is hard frozen, set additional
time. Remember that standing time will further defrost the food
3. Close the door and touch START to continue the cycle if no additional time IS
needed.
4.
Or,
touch in new instructions if additional time is needed.