Tools Needed
Small Phillips screwdriver
Drill with ¼" bit (6 mm)
!
CAUTION
To avoid electrical shock and to prevent damage to the furnace, air condi-
tioner, and thermostat, disconnect the power supply before installing or
servicing the thermostat or any part of the system This can be done at the
circuit breaker for both the furnance and air conditioner
•
Do not reconnect electricity until work is complete
•
Do not short (jumper) across electric terminals at the control on the
furnace or air conditioner to test the system This can damage the
thermostat
•
Your thermostat is a precise instrument Handle it with care
•
All wiring must conform to local codes and ordinances
•
This thermostat is designed for use with 4AA alkaline batteries and/or 24-
volt AC C wire (or a 12- 24 AC or DC source) or millivolt gas systems Each
thermostat relay load should be limited to 1 0 amp; higher amperage can
cause damage to the thermostat
4
Vivint Element CT200 Installation Guide
Getting Started