Factory Reset - Radio Thermostat CT200 User Manual

Factory Reset

Use this procedure only in the event that the network primary
controller is missing or otherwise inoperable
1 From the Home screen, press and hold the SIDE button for three
(3) seconds
2 Press DOWN to highlight Installer, then press the SIDE button
3 Press DOWN to highlight Reset,
then press the SIDE button
4 Press DOWN to highlight Reset,
then press the SIDE button
5. To confirm that you want to
reset the device to factory
defaults, press DOWN to
highlight Reset, then press the
SIDE button
The device resets itself and
reboots You will need to
connect the device to your
Z-Wave Network and specify
your system's equipment and settings See the Installation Guide
Setup section
40
Vivint Element CT200 Operation Guide
Customization
RESET
Are you sure?
Reset