Ricoh SP 220NW Setup Manual page 9

Easy Setup Using a PIN Code
● Before doing the following procedure, install the printer
driver according to the procedure on page 4
"Connecting the Machine (USB/Network)".
● Make sure the Ethernet cable is not connected to the
machine.
● In Steps 12 to 15, configure each setting within two
minutes.
● To establish a connection using the PIN code, use a
computer that is connected to the router (access point).
● The following item is necessary to set up a wireless
connection.
● Router (access point)
1. Check that the router (access point) is working correctly.
2. Open the PIN code configuration window (web page) for the
router (access point) on your computer.
3. On the [Start] menu in your computer, point to [All
Programs], click [SP 220 Series Software Utilities], and then
click [Smart Organizing Monitor for SP 220 Series].
4. Click [User Tools] tab.
5. Click [Printer Configuration].
6. Enter the access code, and then click [OK].
The default access code is "Admin".
7. On the [Network 1] tab, select [Active] for [Wireless
Function:].
8. Click [Apply], and then click [OK].
The machine restarts.
9. Repeat steps 4 to 6 to open the [Printer Configuration]
screen.
10. On the [Wireless] tab, select [Setup with WPS] for
[Configuration Method].
11. Select [Wi-Fi Protected Setup with PIN Code] for [One-
Touch Connection Setting (WPS)].
12. Click [Get PIN Code] and check the PIN code.
Write down the PIN code in case you might forget it.
7