Static Aggregation Configuration Example - H3C S5120-EI Configuration Manual

NOTE:
In an aggregation group, only ports that have the same port attributes and class-two configurations (see
"Configuration
sure that all member ports have the same port attributes and class-two configurations as the reference
port. The other settings only need to be configured on the aggregate interface, not on the member ports.

Static aggregation configuration example

Network requirements
As shown in
Device A and Device B are connected through their respective Ethernet interfaces GigabitEthernet
•
1/0/1 through GigabitEthernet 1/0/3.
Configure a static aggregation group on Device A and Device B, respectively. Enable VLAN 10 at
•
one end of the aggregate link to communicate with VLAN 10 at the other end, and VLAN 20 at one
end to communicate with VLAN 20 at the other end.
• Enable traffic to be load-shared across aggregation group member ports based on the source and
destination MAC addresses.
Figure 12 Network diagram
Configuration procedure
Configure Device A
1.
# Create VLAN 10, and assign port GigabitEthernet 1/0/4 to VLAN 10.
<DeviceA> system-view
[DeviceA] vlan 10
[DeviceA-vlan10] port gigabitethernet 1/0/4
[DeviceA-vlan10] quit
# Create VLAN 20, and assign port GigabitEthernet 1/0/5 to VLAN 20.
[DeviceA] vlan 20
[DeviceA-vlan20] port gigabitethernet 1/0/5
[DeviceA-vlan20] quit
# Create aggregate interface Bridge-Aggregation 1.
[DeviceA] interface bridge-aggregation 1
classes") as the reference port (see
Figure 12:
"Reference port") can operate as Selected ports. Make
46