Omega i-SERIES User Manual page 15

Abbreviations, Range, Default Setup Continued
SEPR (SPCE, _cR_) Data Separation
dAt.F
stAt
RdNG
PEAk
VALY *
GROS **
UNit
AddR
tR.tM
* - For Temperature/Process instrument only
** - For Process/Strain Gauge instrument only
1. There is no Continuous Mode, when device is configured to use the RS-485
interface standard.
2. The Multipoint Address will be included in the transmission data if RS-485
standard has been selected in menu items.
3. Transmit time is available only when device has configured for Continuous
Mode and RS-232 Standard.
4. If the meter is in point-to-point Continuous Mode, it ignores any transmitted
commands except Crtl S, which will stop transmission.
Character
Data Format:
Alarm Status
Reading
Peak
Valley
Gross
Units
Multipoint Address 0000 to 0199 – Addressed Meter
Transmit Time
Interval
Recognition
Character
Space – space inserted after each
piece of data.
Carriage Return – carriage return
inserted after each piece of data
Yes – enables the transmission of
Alarms Value
No – disable
Yes – enables the transmission
of Reading Value
No – disable
Yes – enables the transmission
of Peak Value
No – disable
Yes – enables the transmission
of Valley Value
No – disable
Yes – enables the transmission
of Gross Value
No – disable
Yes – enables the transmission
of Units of Measurement
No – disable
0000 to 5999 sec – transmission
Time Interval between consecutive
transmissions in Continuous Mode.
20 Hex to 7F Hex (32 to 127 Dec)
–see Table 2.1, except "^", "A",
"E"
11
SPCE
_No_
_Yes
_No_
_No_
_No_
_No_
0001
0016
*