Yanmar 3JH4E Service Manual page 87

d) Adjusting other cylinders
See adjustment method for other cylinders
on page 64.
(6) Check and adjust the remote control
operation
The various control levers on the engine side
are connected to the remote control lever by
the remote control cable. The cable will
become stretched and the attachments loose
after long hours of use causing deviation. It is
dangerous to control operation under these
conditions, and the remote control cable must
be checked and adjusted periodically.
1) Adjusting the throttle remote control cable
Check to see that the control lever on the
engine side moves to the high speed stop
position and low speed stop position when the
remote control lever is moved to H (high
speed) and L (low speed) respectively.
When there is deviation, loosen the bracket
for the remote control cable on the engine
side and adjust.
Adjust the high speed stop position first and
then adjust the low speed idling by the
adjustment bolt on the remote control lever.
Never adjust the high speed limiting bolt. This
will void warranty.
2) Adjusting the
marine gear
Check that the shift lever moves to the correct
position, when the remote control handle is
put in NEUTRAL, FORWARD and REVERSE
position.
Use the NEUTRAL position as the standard
for adjustment. When there is deviation,
loosen the clamp for the remote control cable
and adjust the shift lever position.
remote control cable
67R1
2. Inspection and adjustment
Remote control cable
Control lever
Cable joint
High speed limiting bolt
Low speed limiting bolt
Fuel
injection
pump
010615-00E
Remote control cable
Clamp
Shift lever
Marine gear
010616-00E