Stadler Form OSKAR Operating Instructions Manual page 10

Do not use this air humidifier in immediate vicinity of a bath tub, a shower
or a swimming pool (observe a minimum distance of 3 m). Place the ap-
pliance such that a person in the bath tub cannot touch the appliance.
Do not place the appliance near a heat source. Do not subject the power
cord to direct heat (such as a heated hotplate, open flames, hot iron sole
plates or heaters for example). Protect power cords from oil.
See to it that the appliance is properly positioned to ensure a high stabil-
ity during its operation and make sure that no one can trip over the power
cord.
The appliance is not splash-proof.
Do not store or operate the appliance outdoors.
Store the appliance in a dry place inaccessible to children (pack the ap-
pliance).
If the supply cord is damaged, it must be replaced by the manufacturer,
ist service agent or similarly qualified persons in order to avoid a hazard.
This appliance is not intended for use by person (including children) with
reduced physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction-
concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the
appliance.
Preparation for use/operation
1. Place the Oskar big room humidifier on a flat surface in the desired area. Plug
the mains cable (3) into a electric socket. Use the filling opening (11) to fill
the lower part (2) with water up to the maximum mark (14), either at a water
tap or with a watering can. When you have filled the lower part at the tap,
carefully fit the upper part (1) to the lower part (2).
2. Next start the appliance by pressing the on/off switch (5). The blue LED
should then light up. If a red pilot lamp (10) lights up however, this indicates
either lack of water in the appliance or failure to seat the upper part correctly
on the lower part. If there is no water in the appliance, the motor will stop
automatically.
3. By pressing the speed level selector button (6) you can change the humidity
output (1 to 4 LEDs = normal evaporation to high evaporation).
4. You can use the hygrostat to set the desired air humidity. To do this, press
on the hygrostat button (7). You can choose between the following levels:
40% relative air humidity (1 blue LED), 45% (2 blue LED), 50% (3 blue LED),
55% (4 blue LED), constant operation (5 blue LED). If the lamps are flashing,
this indicates that the desired air humidity has already been reached. Please
note that the hygrostat needs about 3 second to measure the current humid-
ity in the room. The hygrostat switches on automatically once the relative air
humidity in the room sinks below the preset value. We recommend that you
set your room humidity to 45% (comfort range).
5. If you find the lamps too bright (in a bedroom for example), you may reduce
the light intensity by pressing the night mode key (8). You can choose be-
tween three different modes: