Table of Contents
Advertisement
.
LED Indicator
Flashes
Briefly
Flashing
On
Off
Note: If using an AUI connection to the server, you can
determine proper polarity by using an AUI to
10Base-T converter box.
Ports 1 Through 16 LED Descriptions
Indicator
Flash
Briefly
1 LED Lit* A RAM self-test failure or other
2 LEDs Lit* Ethernet hardware initialization failure.
3 LEDs Lit* A hardware self-test failure.
4 LEDs Lit* A flash memory configuration error.
* The LEDs light up for a about a minute and then the
hardware resets and the same cycle repeats.
10Base-T LED Descriptions
During the power on cycle (first few
seconds after power turned on), this
turns on briefly to display link polarity
on the 10Base-T connection.
The light flashes briefly during
transmissions as a general indicator of
activity.
VS1000 is correctly attached to the
LAN by the RJ45 10Base-T connector.
VS1000 is not connected to the LAN
properly or it is connected to the AUI
port.
All LEDs light briefly during the power-
on sequence and then turn off.
mainboard error.
Description
Description
Advertisement
Table of Contents
