Advertisement
Switch action
Slide the slide switch forward to start, and
the switch will lock in the "ON" position.
To stop, lightly depress the rear of the
switch, and it will return t o the "OFF"
position.
CAUTION:
Before plugging in the tool, always check
to see that the switch actuates properly
and returns to the "OFF" Position when
depressed.
Operation
Hold the tool firmly. Turn the tool on and
then apply the wheel or disc to the work-
piece.
In general, keep the edge of the wheel or
disc a t an angle of about 15" to the work-
piece surface.
During the break-in period with
a
new
wheel, do not work the grinder in the B
direction or
it
will cut into the workpiece.
Once the edge
of
the wheel has been
rounded off by use, the wheel may be
worked in both A and B directions.
Slide
switch
1
WARNING :
0
If should never be necessary to force the tool. The weight of the tool applies adequate
pressure. Forcing and excessive pressure could cause dangerous wheel breakage.
0
Continued use of a worn-out wheel may result in wheel explosion and serious personal
injury. Depressed center wheel should not be used after it has been worn down to
75 mm (3") in diameter. Use of the wheel after this point
is
unsafe and
it
should be re-
moved from service and rendered unusable
by
intentional destruction.
6
Advertisement
