Camera Ready Light Status - Kodak EasyShare CD43 User Manual

Troubleshooting
If...
Picture is too light
Picture is not clear

Camera ready light status

If...
Ready light does
not turn on and the
camera does not
work
Ready light blinks
green
Ready light blinks
red and camera
turns off
44
Downloaded From camera-usermanual.com Kodak Manuals
Try one or more of the following
I
Reposition camera to reduce the amount of available light.
I
Turn flash off (page
I
Move so that the distance between you and the subject is within the
effective flash range
I
To automatically set exposure and focus, press the Shutter button
halfway. When the Ready light glows green, press the Shutter
button completely down to take the picture.
I
Use Auto, Landscape, or Close-up to adjust the exposure
compensation.
I
To automatically set exposure and focus, press the Shutter button
halfway. When the Ready light glows green, press the Shutter
button completely down to take the picture.
I
Clean the lens (page
I
Make sure camera is not in Close-up mode if you are more than
27.6 in. (70 cm) from your subject.
I
Place the camera on a flat, steady surface or use a tripod, especially
in high-zoom settings or in low light.
Try one or more of the following
I
Turn on the camera
I
Recharge the battery or install a new one
I
Mode dial was on when battery was reloaded. Turn Mode dial off, then
back on.
I
Picture is being processed and saved to the camera. Camera is
operating normally.
I
Camera is connected. Camera is operating normally.
I
Recharge the battery or install a new one
25).
(page 9).
58).
(page 2).
www.kodak.com/go/support
(page 1).
(page 1).