Getting To Know Your Clearview+ Speech; Switching The Clearview+ Speech On And Off; Resetting The Clearview+ Speech; Getting Started - Optelec clearview speech User Manual

Optelec
3.

Getting to know your ClearView+ Speech

This chapter will familiarize you with the operation of the Optelec ClearView+ Speech.

3.1 Switching the ClearView+ Speech on and off

To switch on both the ClearView+ and ClearView+ Speech module, press the ON / OFF button
located right above the magnification button on the reading table. It takes about 10 seconds for the
ClearView+ to initialize before it displays an image. In addition, the start-up process for the
ClearView+ Speech module will take approximately 40 seconds. You will hear the start-up sound to
indicate that the ClearView+ Speech is ready to use.
To switch off the ClearView+ Speech, press the ON / OFF button located right above the
magnification button on the reading table again. The ClearView+ will switch off after which it will take
approximately 40 seconds for the ClearView+ Speech module to power down.

3.2 Resetting the ClearView+ Speech

In case a reset of the ClearView+ Speech is needed, press the black button, located on the right side
of the monitor above the SD card slot to power down the ClearView+ Speech. This will take
approximately 15 seconds. Press this button again after 15 seconds to switch the ClearView+ Speech
back on. After about 40 seconds, the ClearView+ Speech will play the start-up sound to indicate it is
ready to use again.

3.3 Getting started

To get started with your ClearView+ Speech:
Step 1:
Switch the ClearView+ Speech on with the <red> button.
Step 2:
After 40 seconds the ClearView+ Speech will play a start up sound.
Now, tap the screen in the bottom right corner to activate speech.
Step 3:
Place the document you want to read under the ClearView+
Speech, inside the document outline, which is shown on the
monitor.
ClearView Speech
Page 6