To Adjust The Needle Bar Height - Janome Memory Craft 3000 Service Manual

To adjust the needle bar height

The standard distance between the upper edge of the needle eye (A) and the tip of shook
should be in the range of 1.6 to 2.0 mm when the tip of hook meets the right side of the needle
(B) in ascending travel of needle from its left and lowest position.
1. Remove the needle plate & bobbin holder.
2. Turn on the power switch and select the pattern (straight stitch at the left needle position).
3. Turn the balance wheel toward you until tip of hook meets the right side of the needle (B).
4. Loosen the needle bar connecting stud set screw (C).
5. Adjust the height of the needle bar by moving the needle bar upward or downward without
turning it. (Make sure that the needle setting groove (D) on the needle bar is in the front).
6. Tighten the set screw (C).
7. Insert the bobbin holder.
8. Attach the needle plate.
7