Buttonhole Sensor Attaching And Removing - Janome Memory Craft 3000 Service Manual

Buttonhole sensor attaching and removing

(TO REMOVE)
1. Remove the front panel (See page 4).
2. Remove screw (A) and remove the buttonhole sensor unit (B) from the sensor set plate (C).
3. Pull out the connector (D) of buttonhole sensor unit from the Board K.
4. Pull out the cord (F) of buttonhole sensor unit from cord guide (E) and remove the button-
hole sensor unit (B).
(TO ATTACH)
5. Insert the buttonhole sensor cord (F) through the front bracket unit (G), cord guide plate (H)
and the two cord guides (E).
6. Insert the connector (D) for buttonhole sensor unit into Board K.
7. Attach the BH sensor unit to the sensor set plate and adjust so that the shield plate does
not touch the buttonhole sensor unit (B) when moving.
8. Tighten screw (A).
9. Attach the front panel unit.
NOTE: When replacing the buttonhole sensor unit, check the adjustment of the buttonhole
lever (See page 16).
25