Checklist Procedures; Preflight Inspection; Empennage; Right Wing Trailing Edge - Cessna 182Q 1979 Pilot Operating Handbook

CESSNA
MODEL 182Q
SECTION 4
NORMAL PROCEDURES
CHECKLIST PROCEDURES
PREFLIGHT INSPECTION
(DCABIN
1.
Pilot's Operating Handbook -- AVAILABLE IN THE AIRPLANE.
2. Control Wheel Lock -- REMOVE.
3. Ignition Switch -- OFF.
4. Avionics Power Switch -- OFF.
5. Master Switch -- ON.
J
WARNING
~
When turning on the master switch, using an external
power source, or pulling the propeller through by hand,
treat the propeller as if the ignition switch were on. Do not
stand, nor allow anyone else to stand, within the arc of the
propeller, since a loose or broken wire, or a component
malfunction, could cause the propeller to rotate.
6. Fuel Quantity Indicators -- CHECK QUANTITY.
7. Master Switch -- OFF.
8. Static Pressure Alternate Source Valve
(if
installed) -- OFF.
9. Fuel Selector Valve -- BOTH.
10. Baggage Door -- CHECK for security, lock with key if child's seat
is to be occupied.
®EMPENNAGE
1.
Rudder Gust Lock -- REMOVE.
2. Tail Tie-Down -- DISCONNECT.
3. Control Surfaces -- CHECK freedom of movement and security.
@)
RIGHT WING Trailing Edge
1.
Aileron -- CHECK freedom of movement and security.
@)
RIGHT WING
1.
Wing Tie-Down -- DISCONNECT.
2. Fuel Tank Vent Opening -- CHECK for stoppage.
3. Main Wheel Tire -- CHECK for proper inflation.
1 October 1978
4-5