Input Cable Installation; Status Led's - Triax HDMI module 492030 User Manual

Basics
Input cable
installation
Status LED
When all the required input modules have been installed you can connect the
input signal cables one by one to the input modules.
When you connect the cable to the input connector on the module, remember
to tighten the screws connecting the AV plug to the connector.
There is a status LED on the front of each module. The LED indicates whether
the module has locked on to a frequency or needs to be configured.
Green - flashing
Green
Red
No colour
HDMI
9
492030
Status LED
The module has not been configured yet.
No error, MPEG encoding valid.
Module has been configured but no service has been
detected.
Power has not been switched on.
6
A/V A/V
6
492080 492080