Mitsubishi Electric MELSEC FX Series User Manual page 120

FX communication
4 ) Operation
X000,ON
RS instruction
drive
X001,ON
Turn on the power of the
programmable controller and printer,
Power on
check the printer is on line and switch
the programmable controller to RUN.
Turn on X000, and drive RS
instruction.
Every time X001 is turned on, the
contents of D200 to D210 are sent
Data send
to the printer, and "test line" is
printed.
RS instruction 9
In this example,CR (H000D) and
·
x
LF (H000A) are written at the
y
end of the message. The printer
moves down one line for each
meessage.
CR: Carriage Return
z
LF: Line Feed
Note:lt may be necessary to set
the DIP switches of your printer.
{
Check your printer manual for
|
how to configure the serial
communications.
9-18