Cutting - Hitachi CJ 14DSL Handling Instructions Manual

11. About Remaining Battery Indicator
When pressing the remaining battery indicator
switch, the remaining battery indicator lamp lights
and the battery remaining power can be checked.
(Fig. 15) When releasing your fi nger from the
remaining battery indicator switch, the remaining
battery indicator lamp goes off . The Table 4 shows
the state of remaining battery indicator lamp and the
battery remaining power.
State of lamp
As the remaining battery indicator shows somewhat diff erently depending on ambient
temperature and battery characteristics, read it as a reference.
NOTE
Do not give a strong shock to the switch panel or break it. It may lead to a trouble.
○
To save the battery power consumption, the remaining battery indicator lamp lights while
○
pressing the remaining battery indicator switch.

CUTTING

CAUTION
In order to prevent blade dislodging, damage or excessive
○
wear on the Plunger, please make sure to have surface of
the base plate attached to the work piece while sawing.
At low speed do not cut a wood with a thickness of more
○
than 10 mm or metal with a thickness of more than 1 mm.
1. Rectilinear cutting
When cutting on a straight line, fi rst draw a marking gauge line
and advance the saw along that line. Using the guide (sold
separately) will make it possible to cut accurately on a straight
line.
(1) Loosen the base bolt hexagonal bar wrench attached on base.
(Fig. 16)
(2) Move the base fully forward (Fig. 17), and tighten the base bolt
again.
Table 4
Battery Remaining Power
The battery remaining power is enough.
The battery remaining power is a half.
The battery remaining power is nearly empty.
Re-charge the battery soonest possible.
33
English
Remaining battery
indicator lamp
Remaining battery
indicator switch
Fig. 15
Base
Base
bolt
Hexagonal bar wrench
Fig. 16
Base
Forward
Fig. 17