1.
Hard disk installation of replacement
A. Hard disk installation
After turning on the power of the device, unplug the power from the outlet.
① Loosen the screw on the left, right and rear side of the product.
② Separate the cover of the main unit.
③ Remove the screws on the bracket holding the hard disk, separate the bracket
from the hard disk.
④ Install the hard disk to the bracket and tighten the 4 screws.
⑤ Connect the SATA cable to the hard disk.
⑥ Connect the SATA cable to the SATA port of the main board.
- The SATA cable port on the main board must be connected at all times. If a
<HDD power cable>
hard disk is not connected, this device may not operate normally.
<HDD SATA cable>
13
U
M
SER
ANUAL
H.264 R
T
DVR
EAL
IME