AEG mc1763e User Manual page 123

9.2 Safe use of the appliance
If fitting the microwave in position B or C:
• The cupboard must be a minimum of
500 mm (E) above the worktop and
must not be installed directly above a
hob.
• This appliance has been tested and
approved for use near domestic gas,
electric and induction hobs only.
9.3 Connecting the appliance to the power supply
• The electrical outlet should be readily
accessible so that the unit can be
unplugged easily in an emergency.
Or it should be possible to isolate the
oven from the supply by
incorporating a switch in the fixed
wiring in accordance with the wiring
rules.
(A)
• Sufficient space between hob and
microwave should be allowed to
prevent overheating of microwave
oven, surrounding cupboard and
accessories.
• Do not operate the hob without pans
when the microwave oven is
operating.
• Care should be taken when
attending to the microwave oven
while the hob is on.
• The socket should not be positioned
behind the cupboard.
• The best position is above the
cupboard, see (A).
• Connect the appliance to a single
phase 230 V/50 Hz alternating
current via a correctly installed earth
socket. The socket must be fused
with a 10 A fuse.
• The power supply cord may only be
replaced by an electrician.
• Before installing, tie a piece of string
to the power supply cord to facilitate
connection to point (A) when the
appliance is being installed.
• When inserting the appliance into the
high-sided cupboard, DO NOT crush
the power supply cord.
• Do not immerse the power supply
cord or plug in water or any other
liquid.
ENGLISH 123