Engine Board Removal - Lexmark T520 Service Manual

Infoprint 1120 and 1125

Engine Board Removal

1. Remove the inner EMC shield.
2. Disconnect all cables from the engine board.
3. Remove the engine board mounting screws (A).
4. Remove the engine board shield mounting screw (B) from the
main drive motor assembly.
5. Remove the engine board.
Note: Anytime the engine board is replaced, the Configuration ID
must be reset in NVRAM on the new engine board. Go to
Configuration ID" on page 3-20.
"Setting
Repair Information
4-23